[GE users] Queue configuration

Noé Vázquez González nvazquezg at gmail.com
Wed May 7 18:47:37 BST 2008


    [ The following text is in the "ISO-8859-1" character set. ]
    [ Your display is set for the "ISO-8859-10" character set.  ]
    [ Some special characters may be displayed incorrectly. ]

Thank you very much for the answers, that is what I need ;)

Noé


2008/5/7 Erik Soyez <E.Soyez at science-computing.de>:

> Good Morning Noé,
>
> a PE "allocation_rule" of "$fill_up" should almost do the job.
> But if there was, for example, one host with 8 free cpus and
> some load and two hosts with 4 free cpus each and no load the
> job would spread over the two hosts with lower load - I think.
>
> To be sure:  Set up two queues smp and dmp, give the smp queue
> a lower sequence number, configure seqno as sort_method, add the
> two PEs pe_smp and pe_dmp to the corresponding queues and make
> their allocation_rules $pe_slots and $_fill_up respectively.
>
> Qsub your job with "-pe pe_\* 8".
>
> Erik Soyez.
>
>
>
> On Tue, 6 May 2008, Noé Vázquez González wrote:
>
>  Hi All,
> >
> > Is it possible to set up a parallel queue as follows?
> >  - If a node has enough free cpus for the job, run it on that node.
> >  - If there isn't a node with enough free cpus, spread the job between
> > the
> > nodes as usual.
> >
> > For example, a parallel job that requires 8 cpus, if there is a node
> > with 8
> > free cpus asign the job to 8 cpus of that node. If there isn't 8 cpus
> > avaliable on the same node, spread the job between other nodes as usual
> > depending on their load (4 4, 2 2 2 2, etc.)
> >
> > Thanks.
> >
> > Noé
> >
>
>
> --
> --
> Vorstand/Board of Management:
> Dr. Bernd Finkbeiner, Dr. Florian Geyer,
> Dr. Roland Niemeier, Dr. Arno Steitz, Dr. Ingrid Zech
> Vorsitzender des Aufsichtsrats/
> Chairman of the Supervisory Board:
> Prof. Dr. Hanns Ruder
> Sitz/Registered Office: Tuebingen
> Registergericht/Registration Court: Stuttgart
> Registernummer/Commercial Register No.: HRB 382196
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: users-unsubscribe at gridengine.sunsource.net
> For additional commands, e-mail: users-help at gridengine.sunsource.net
>



More information about the gridengine-users mailing list