[GE users] Grid engine without shared filesystem

udo udo at physics.rutgers.edu
Wed Mar 4 03:25:21 GMT 2009


Hi, guys,

One  can also use automount to mount $SGE_ROOT/$SGE_CELL/common directory
only for a minute or two until job is submitted and then when it is done.
NFS traffic is almost zero.
Best,
v

-----Original Message-----
From: magawake [mailto:magawake at gmail.com] 
Sent: Tuesday, March 03, 2009 9:16 PM
To: users at gridengine.sunsource.net
Subject: RE: Re: [GE users] Grid engine without shared filesystem

To install with this type of setup, proceed as follows:

   1.

      unpack/untar the Grid Engine distribution on each system (common and
architecture-specific packages) to the same pathname on each system
   2.

      install the master host completely
   3.

      modify all the configuration files mentioned above to suit the
requirements of your site
   4.

      on the master hosts make an archive of the directory
$SGE_ROOT/$SGE_CELL/common
   5.

      on each exec host, unpack the archive created above
   6.

      on each exec host, run the install_execd script. It should
automatically read in the configurations from the directory which was
unpacked.


DUH! 

I will follow this.

Rayson and the community. Thanks for the quick reply! This product would not
be where it is without the awesome community support.

------------------------------------------------------
http://gridengine.sunsource.net/ds/viewMessage.do?dsForumId=38&dsMessageId=1
20025

To unsubscribe from this discussion, e-mail:
[users-unsubscribe at gridengine.sunsource.net].

------------------------------------------------------
http://gridengine.sunsource.net/ds/viewMessage.do?dsForumId=38&dsMessageId=120073

To unsubscribe from this discussion, e-mail: [users-unsubscribe at gridengine.sunsource.net].



More information about the gridengine-users mailing list