[GE users] Cannot change number of slots

templedf dan.templeton at sun.com
Tue May 19 20:40:45 BST 2009


Long story. Here's a summary:

http://blogs.sun.com/roller/page/templedf?entry=understanding_purge

Basically, the easiest way to fix your problem is to use qconf -mq 
queuename and then change the slots attribute from 
"1,[host=1],[host=1]..." to "2".

Daniel

rmc7777 wrote:
> Hi,
>
> I'm trying to change the number of slots from 1 to 2 on each of the execution hosts in our queue complex (there are 30 hosts in the queue complex).  Entering
>
> qconf -mattr exechost complex_values slots=2 hostname
>
> on all hosts seems to run without errors, but the command
>
> qconf -sq queuename
>
> still shows the number of slots as 1 on all hosts.  Are we using the right commands for this?
>
>
> --------------------------------------------
> Richard Casey, PhD
> RMRCE/CSUCB/CEM
> Campus Delivery 1690
> Colorado State University
> Ft. Collins, CO   80523
> Ph:  970-491-8568
> Cell: 970-980-5975
> Email: richard.casey at colostate.edu
>
> ------------------------------------------------------
> http://gridengine.sunsource.net/ds/viewMessage.do?dsForumId=38&dsMessageId=197491
>
> To unsubscribe from this discussion, e-mail: [users-unsubscribe at gridengine.sunsource.net].
>

------------------------------------------------------
http://gridengine.sunsource.net/ds/viewMessage.do?dsForumId=38&dsMessageId=197493

To unsubscribe from this discussion, e-mail: [users-unsubscribe at gridengine.sunsource.net].



More information about the gridengine-users mailing list